RFM Memory Size
The RFM checks all required calculations against available array space and,
if insufficient, returns an error message
indicating the limiting parameter (MAX...). It should not be possible
for the user-inputs to cause an array bound overflow error (if this does
happen, please report it as a bug).
Most of the parameters determining RFM array sizes are contained in the
include file rfmsiz.inc, and can be increased as required without
significantly affecting the total memory requirements.
However the following (common block) arrays
constitute most of the RFM memory space and
increasing their dimensions may create problems:
- (in file fincom.inc)
- REAL ABSFIN(MAXFIN,MAXCLC) ! Fine mesh absorption
- REAL CNTFIN(MAXFIN,MAXCLC) ! Fine mesh path non-LTE factor
- (in file widcom.inc)
- REAL ABSWID(3,MAXWID,MAXCLC) ! Widepass abs. by parabolic point
- REAL CNTWID(3,MAXWID,MAXCLC) ! Widepass nonlte factor by parab.pt.
The dimension 3 relates to storing parameters for quadratic
interpolation and cannot be altered, but the
other dimensions can be modified:
- Maximum number of calculated paths.
Should be of the order of the (number of absorbers) x (number of atmospheric
layers + number of tangent paths)
- Maximum number of widemesh intervals. Since each
interval is 1 cm-1 wide,
this should be set to the maximum width, in cm-1
required for a single
spectral range, plus 4 to allow for overlaps and ILS convolution.
- Maximum number of finemesh grid points per widemesh
interval. A value of 2000 is normally required for accurate
limb-viewing calculations (ie 2000 pts/cm-1).
While maximum values of MAXWID and
MAXFIN can be predicted, MAXCLC can often prove
too small, resulting in a fatal error message, e.g.
In this case, the following measures are suggested (in order of preference)
F-TANPTH: No.paths for line-by-line calc= 1625 >MAXCLC in RFMSIZ= 1260
- Increase the size of MAXCLC by a factor 2, say,
and recompile the code, provided that this does
not exceed the RAM limit of the machine (in which case there will be
a system error message when you attempt to run the code).
- Redefine the calculation to reduce the number of calculated paths
by altering either the
file spacing (see RFM Optimisations),
or reduce number of tangent
points required in a single run.
- Increase MAXCLC while reducing MAXWID and/or
MAXFIN to maintain total RAM space, subject to caveats